[. . . ] This equipment has been tested and found to comply with the limits for Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] If the remote control unit is not available, you can turn on/off the monitor by pressing the (power) switch on the monitor with a pointed object. * If the remote control unit is not available, you can select the input terminal by pressing the input switch on the monitor with a pointed object. Press the MUTE button again to turn the sound back to the previous level. VOL +/- (Volume adjustment) Pressing or displays the VOLUME menu when the menu screen is not displayed. * If you do not press any buttons for about 4 seconds, the VOLUME menu automatically disappears. BRIGHT +/- (Backlight adjustment) Pressing or displays the BRIGHT menu when the menu screen is not displayed. * If you do not press any buttons for about 4 seconds, the BRIGHT menu automatically disappears. SIZE (Screen size selection) Each time you press this button, the screen size changes in the following order (see pages 21 and 22): · MODE (Screen mode selection) Each time you press this button, the screen mode changes in the following order: · Color conversion is made in taking account of liquid crytal's characteristics and represents color tone close to its original image. The display disappears when this button is pressed again or disappears automatically after approximately 15 seconds. Even when the screen size is changed, the display may remain the same depending on the input signal. An image with a 4:3 aspect ratio is enlarged to fill the entire screen without changing the aspect ratio. When using the adjustment pattern (see page 31), make adjustments so that no vertical stripe noise appears in it. Adjustments to PHASE should be made only after CLOCK has been correctly set. Selecting + changes the color towards green, and selecting - changes it towards magenta. [OFF TIMER] Set the time until the monitor turns off (enters standby mode) between 0 and 23 in units of one hour. When the time specified in MOTION TIME 1 elapses, the screen image is moved vertically and horizontally for a certain period of time at the interval specified in MOTION TIME 2. After the movement stops and the time specified in MOTION TIME 1 elapses again, SCREEN MOTION activates again. While the screen image is moving, the edges of the screen may be hidden. [POWER ON DELAY] You can delay the screen display after the monitor is turned on. SET] Assigns ID numbers to monitors connected in a daisy chain (see page 36), using RS-232C cables. If "0" is set, the system regards this as the state where no ID number is set. [ENLARGE] (DIGITAL/ANALOG) Sets the number of screen splits used for the enlargement. [. . . ] Before calling for repair services, make sure following checks for possible remedies to the encountered symptoms. If any external equipment is connected, make sure the equipment is operating (playing back). Make sure audio cables for external speakers are connected properly: left and right cables may be reversed or one of the two cables may not be connected. Try the automatic screen adjustment when the PC analog RGB input terminal is used. [. . . ]